REPLACEMENT OF RECORDING PAPER IN ECHO SOUNDER

1.switchoff the echo sounder.

2.Rotate the pen belt so that the recording pen is located below the lower belt pulley.

3.Take hold of the top front of the recording unit,pull it out and let the unit swing down carefully.

4.Open the paper-Transport rollers by pullying the left hand roller to the left and out..

5.Pull out the end disc knob for the magazine and remove the used paper roll.

6.Transfer the empty spool from right to left side and make sure that the end supporting discs enter the spool.

7.Install a new roll of recording paper and pull the paper out between the belt and the front,under the scale and then in between the paper transport rollers and around the empty spool.

8.Thread the end of the paper into the slot in the paper spool and turn the spool so that the paper becomes tight and doesnot lie loosely against the front.Then close the paper transport rollers.

9.Finally engage the recorder unit back into its place.

Note:
There are two switches inside the electronic unit cover,which for Navigation purposes are set as follows.
TVG-SWITCH to position
FUNCTION SWITCH to position I

The switches are set at the factory and should not be used.